Raspberry Waveshare
I 10 migliori prodotti di novembre 2024
Ultimo aggiornamento:
13 novembre 2024
Waveshare
Waveshare Raspberry Pi 5inch Capacitive 5-Points Touch Display, Support 800×480 Resolution with DSI Interface Low Power Consumption
Spedizione gratuita
98
QUALITÀ MASSIMA
VEDI SU AMAZON
Amazon.it
#1 VINCITORE
▼ Mostra di più
▲ Mostra di meno
Supports Raspbian, 5-points touch, driver free
Supports Ubuntu / Kali / WIN10 IoT, single point touch, driver free
Supports Retropie, driver free
Supports Pi 4B/3B+/3A+/3B/2B/B+/A+, CM3/3+/CM3/3+ requires extra adapter board
Adjustable Brightness Via Software
46,99 € SU AMAZON
Waveshare
Waveshare RS485 CAN HAT for Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+ Allows Stable Long Distance Communication
Spedizione gratuita
96
QUALITÀ SUPERIORE
VEDI SU AMAZON
Amazon.it
#2
▼ Mostra di più
▲ Mostra di meno
Raspberry Pi connectivity, compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+
CAN function, onboard CAN controller MCP2515 via SPI interface, with transceiver SN65HVD230
RS485 function, controlled via UART, half-duplex communication, with transceiver SP3485
Reserved control pins, allows to work with other control boards
Comes with development resources and manual (examples in wiringPi/python)
19,99 € SU AMAZON
Waveshare
Waveshare PoE Power Over Ethernet HAT (F) Compatibele with Raspberry Pi 5, High Power, Onboard Cooling Fan, with Metal Heatsink, Supports 802.3af/at Network Standard
Spedizione gratuita
94
QUALITÀ OTTIMA
VEDI SU AMAZON
Amazon.it
#3
▼ Mostra di più
▲ Mostra di meno
The PoE HAT (F) is a 802.3af/at-compliant Power Over Ethernet accessory for the Raspberry Pi 5. By using this small HAT and some proper 802.3af/at-compliant power sourcing equipments, it is possible to provide both network connection and power supply for your Raspberry Pi in only one Ethernet cable.
Standard Raspberry Pi 40PIN GPIO header, supports Raspberry Pi 5
PoE (Power Over Ethernet) capability，IEEE 802.3af/at-compliant Fully isolated switched-mode power supply (SMPS)
Onboard high speed active cooling fan, with metal heatsink, better heat dissipation
Provide e-user manual, please check the manual carefully before using!
30,99 € SU AMAZON
Waveshare
Waveshare Raspberry Pi 1.3inch IPS LCD Display HAT, 240x240 Pixels with embedded controller, communicating via SPI interface
91
QUALITÀ DISTINTA
VEDI SU AMAZON
Amazon.it
#4
▼ Mostra di più
▲ Mostra di meno
Please note:fbtft_device and flexfb are gone in 5.4.fbtft_device was removed because the gpio code had been reworked without fixing up fbtft_device so it didn't work.
This is an IPS LCD display HAT for Raspberry Pi, 1.3inch diagonal, 240x240 pixels, with embedded controller, communicating via SPI interface.Standard Raspberry Pi connectivity, compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+
IPS screen, wide viewing angle, better display High definition in small size 1x joystick, 3x pushbuttons, handy and useful
Comes with development resources and manual (examples for Raspberry Pi)
Driver: ST7789;Display color: RGB, 65K color;perating voltage: 3.3V
19,99 € SU AMAZON
Waveshare
Waveshare for Raspberry Pi 5 Case,DIN Rail ABS Case for Raspberry Pi 5,Large Inner Space, Compatible with Raspberry Pi Expansion Board Poe Hat (F), RS485 Can Hat, 2-CH RS485 Hat
Spedizione gratuita
84
QUALITÀ AFFIDABILE
VEDI SU AMAZON
Amazon.it
#5
▼ Mostra di più
▲ Mostra di meno
[DIN Rail ABS Case For Raspberry Pi 5]DIN Rail Mount Support, ABS Material, Clear Top Window, Large Inner Space
[DIN Rail Mount Support] Injection Moduling ABS Body With Rail Mount Support, Easy-To-Use
[Compatible With Various Raspberry Pi HATs] The Large Inner Space Allows Accommodating An Extra Add-On
[Customize Opening Service] Design Your Unique Case, The Opening Is Customizable For 200PCS Or More.
Ingenious Opening Design
15,19 € SU AMAZON
Waveshare
Waveshare 4.3inch Capacitive Touch Display for Raspberry Pi with Protection Case 800×480 Resolution IPS Wide Angle MIPI DSI Interface,Compatible with Raspberry Pi 4 ONLY
Spedizione gratuita
82
QUALITÀ AFFIDABILE
VEDI SU AMAZON
Amazon.it
#6
▼ Mostra di più
▲ Mostra di meno
Note：The case can compatible with Raspberry Pi4B only,other Raspberry pi models can choose the version not include the case. Supports Raspberry pi, 5-points touch, driver free.
Supports Ubuntu / Kali / WIN10 IoT, single point touch, driver free.
Supports Retropie, driver free. Supports Pi 4B/3B+/3B.
Raspberry Pi is NOT included.
The case is 3D-printed, so you may feel the surfaces is a little bit rough, please make sure you don't mind it before purchasing.
49,99 € SU AMAZON
Waveshare
Waveshare 2.13 Inch e-Paper Display HAT V4 250x122 Resolution E-Ink Screen Electronic Paper Module with Embedded Controller Partial refresh for Raspberry Pi/Jetson Nano/Arduino,Support SPI Interface
Spedizione gratuita
78
QUALITÀ BUONA
VEDI SU AMAZON
Amazon.it
#7
▼ Mostra di più
▲ Mostra di meno
V4 Latest Version.Note:Please use corresponding demo code in wiki.No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+,Jetson Nano
SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc. Onboard voltage translator, compatible with 3.3V/5V MCUs
Comes with development resources and manual (examples for Raspberry/Jetson Nano/Arduino/STM32)
20,99 € SU AMAZON
Waveshare
Waveshare 2-Channel Isolated CAN Bus Expansion HAT For Raspberry Pi 5/4/3/Zero Dual Chips Solution Stackable Design For Expanding Multiple CAN Channels Supports Wide Range Voltage Input of 7~36V
Spedizione gratuita
77
QUALITÀ BUONA
VEDI SU AMAZON
Amazon.it
#8
▼ Mostra di più
▲ Mostra di meno
Standard Pi 40PIN GPIO extension header, compatible with Raspberry Pi/Jetson Nano series boards. Adopts MCP2515 and SN65HVD230 dual chips combined solution, allows 2-channel CAN communication
Onboard unibody power supply isolation, providing stable isolated voltage, requires no extra power supply for the isolated terminal. Onboard digital isolator, signal isolation makes the communication more safe and stable, and better anti-interference
Onboard external power supply terminal, supports 7~36V wide voltage power input, supports powering the Pi and the HAT at the same time. Onboard SM24CANB TVS (Transient Voltage Suppressor) diode, provides ESD protection and transient peak voltage protection
Onboard voltage translator, select 3.3V/5V operating voltage by jumper. Onboard 120Ω terminal resistor, configured by jumper
Breakout SPI and I2C control pins, for connecting with other host control boards. Can provide with online development resources and manual (examples in Python/C)
36,99 € SU AMAZON
Waveshare
Waveshare UPS HAT (B) for Raspberry Pi 5V Uninterruptible Power Supply 5A High Current with Pogo Pins Connector
Spedizione gratuita
75
QUALITÀ BUONA
VEDI SU AMAZON
Amazon.it
#9
▼ Mostra di più
▲ Mostra di meno
Designed for Raspberry Pi series, compatible with Raspberry Pi 3 / 3B+ / 4B, etc.
I2C bus communication, monitoring the batteries voltage, current, power, and remaining capacity in real time
Multi battery protection circuits: over charge/discharge protection, over current protection, short circuit protection, and reverse protection, along with the equalizing charge feature, more safe and stable
Onboard 5V regulator, up to 5A continuous output current, more sufficient power source for Raspberry Pi
5V USB output, convenient for powering other boards Batteries warning indicators, easy to check if the battery is connected correctly
31,99 € SU AMAZON
Waveshare
Waveshare Raspberry Pi AD/da Expansion Sheild Board for Adding High-Precision AD/da Functions to Raspberry Pi Onboard ADS1256 DAC8552 Sensor Interface
Spedizione gratuita
66
QUALITÀ BUONA
VEDI SU AMAZON
Amazon.it
#10
▼ Mostra di più
▲ Mostra di meno
Onboard ADS1256, 8ch 24bit ADC ad alta precisione (4ch differenziale input), frequenza di campionamento 30ksps.
Onboard DAC8532, 2ch 16bit DAC ad alta precisione
Interfaccia di ingresso integrata tramite pinheaders, per il collegamento del segnale analogico, il pinout è compatibile con interfaccia del sensore Waveshare standard, facile da collegare vari moduli di sensore analogico.
Interfaccia di ingresso/uscita integrata tramite terminali a vite, per il collegamento di segnale analogico/digitale.
Dispone di circuito di rilevamento AD/DA, facile per dimostrazione del segnale.
48,99 € SU AMAZON
waveshare raspberry
waveshare display raspberry
raspberry
#1 VINCITORE
