Raspberry Hat
I 10 migliori prodotti di febbraio 2025
Ultimo aggiornamento:
24 febbraio 2025
Geekworm
Geekworm X1001 PCIe to M.2 NVMe SSD Shield per Raspberry Pi 5
Spedizione gratuita
98
QUALITÀ MASSIMA
VEDI SU AMAZON
Amazon.it
#1 VINCITORE
▼ Mostra di più
▲ Mostra di meno
【Compatibility】only for Raspberry Pi 5 8GB / 4GB (NOT included)
【Matching Case (NOT included)】P579 Case (ASIN: B0CRB3DT5M); Or P579 Case with Official Active Cooler (ASIN: B0CT4P893Q)
【M2 Key-M NVMe SSD Supported】Support M.2 KEY-M NVMe SSD 2230/2242/2260/2280 length installation.【IMPORTANT】DON'T use NVMe SSD with Phison controller, please refer to: https://wiki.geekworm.com/X1001#Important_Notes
【How to Power】Use 5Vdc +/-5%, 5A to power via Raspberry Pi 5, and Pi 5 will power X1001 via FFC PCIe ribbon. Recommend to use Geekworm PD 27W power adapter (ASIN: B0CP8SRXSC / B0CZCZF2QV)
【Packing List】1 x X1001 Shield, 1x Accessories Pack
16,40 € SU AMAZON
Freenove
Freenove Breakout Board for Raspberry Pi 5 / 4B / 3B+ / 3B / 3A+ / 2B / 1B+ / 1A+ / Zero 2 W/Zero W/Zero, Terminal Block Shield HAT with Pin Header, GPIO Status LED
Spedizione gratuita
96
QUALITÀ SUPERIORE
VEDI SU AMAZON
Amazon.it
#2
▼ Mostra di più
▲ Mostra di meno
Compatible Models: Raspberry Pi 5 / 4B / 3B+ / 3B / 3A+ / 2B / 1B+ / 1A+ / Zero 2 W / Zero W / Zero (Note: NOT compatible with 500 / 400)
GPIO Status LED: LED on if GPIO outputs / inputs high level, LED off if GPIO outputs / inputs low level
Independent LED: The status LED is driven by the chip instead of the GPIO so the GPIO will not be affected
Terminal Block and Header: Connect to all pins of Raspberry Pi's 40-pin GPIO header, 2.54 mm (0.1 inch) pitch
Pin Name: The BCM numbering name of each pin is printed next to it
11,95 € SU AMAZON
Waveshare
Waveshare PCIe to 2-CH M.2 HAT+ Adapter Type B Compatible with Raspberry Pi 5, Support 2280/2260 / 2242/2230 Size NVMe Protocol M.2 SS Solid State Drive High-Speed Reading/Writing NVMe HAT
Spedizione gratuita
96
QUALITÀ SUPERIORE
VEDI SU AMAZON
Amazon.it
#3
▼ Mostra di più
▲ Mostra di meno
PCIe To 2-Ch M.2 Adapter Type B For Raspberry Pi 5, Compatible With 2280 / 2260 / 2242 / 2230 Size NVMe Protocol M.2 Solid State Drive , 5Gbps Data Rate, High-Speed Reading/Writing, Raspberry Pi 5 NVMe HAT.Adopts Anti-Oxidation Immersion Gold Process
✅【Connecting To PI5 Via 16PIN Cable】Based On 16PIN PCIe Interface Of Raspberry Pi 5
✅【Dual NVMe Solid State Drives Support】Compatible With 2280 / 2260 / 2242 / 2230 Size M.2 Solid State Drives Supports PCIE X1 Gen2 Only, Supports Booting PI5 From Solid State Drive
✅【NVMe Drive Slot Support】Note: Only supports the NVMe Protocol Solid State Drives.
✅【Improves Reading/Writing Speed Of Your Pi】Faster Reading/Writing Speed Compared To The TF Card Slot Of Raspberry Pi , Greatly Improving Reading/Writing Efficiency Of The System Or Files, Supports Booting Pi5 From NVME Solid State Drive.(As Raspberry Pi does not support booting from NVME by default, you need to modify it to realize it.)
✅【Onboard Dual LED Indicators】Easy To Monitor The Working Status. 【Onboard Power Monitoring Chip And EEPROM】Real-Time Monitoring Of Solid State Drive Power Status For More Stable Operation
❤️Rich WiKi Resources❤️ We provide official Wiki resources, please contact us for more information.
27,99 € SU AMAZON
Raspberry Pi
M.2 HAT+ pour Raspberry Pi 5
Spedizione gratuita
88
QUALITÀ DISTINTA
VEDI SU AMAZON
Amazon.it
#4
Waveshare
Waveshare Poe Hat (F) for Raspberry Pi 5, 802.3af/at-Compliant, Power Over Ethernet Hat Expansion Board for Raspberry Pi 5, with Metal Heatsink,Onboard Cooling Fan
Spedizione gratuita
86
QUALITÀ AFFIDABILE
VEDI SU AMAZON
Amazon.it
#5
▼ Mostra di più
▲ Mostra di meno
POE HAT with standard Raspberry Pi 40PIN GPIO header, compatible with Raspberry Pi 5
By using this small HAT and some proper 802.3af/at-compliant power sourcing equipments, it is possible to provide both network connection and power supply for your Raspberry Pi in only one Ethernet cable.
PoE (Power Over Ethernet) capability，IEEE 802.3af/at-compliant.x
Fully isolated switched-mode power supply (SMPS)
Onboard high speed active cooling fan, with metal heatsink, better heat dissipation
29,90 € SU AMAZON
Waveshare
Power over Ethernet (PoE) HAT per Raspberry Pi 4B / 3B+, Standard 802.3af/at PoE Rete, 5V USB-A e 12V Uscite Header, Ventola di Raffreddamento HAT PoE Integrata e Chip Buck MP8676, Isolato
Spedizione gratuita
82
QUALITÀ AFFIDABILE
VEDI SU AMAZON
Amazon.it
#6
▼ Mostra di più
▲ Mostra di meno
【PoE HAT For Raspberry Pi 4B/3B+】Standard Raspberry Pi 40PIN GPIO header, supports Raspberry Pi 3B+/4B, allows Power Over Ethernet HAT connecting other HATs.
【Power Over Ethernet】PoE (Power Over Ethernet) capability, IEEE 802.3af/at-compliant power sourcing equipments, providing both network connection and power supply for your Raspberry Pi in one Ethernet cable.
【PoE HAT Isolated】Fully isolated switched-mode power supply (SMPS)
【5V USB-A & 12V Header Outputs】5V USB-A provides up to 4A output (MAX 25W for 12V+5V total output power), While providing stable power for the Raspberry Pi, there's also a USB-A port for powering extra external device.
【Onboard Cooling Fan and MP8676 Buck Chip】PoE HAT with high speed active cooling fan, better heat dissipation, incorporates MP8676 original voltage buck chip, providing up to 4.5A output for Raspberry Pi and USB-A port.
24,99 € SU AMAZON
Waveshare
RS485 CAN HAT per Raspberry Pi 4B/3B+/3B/2B/B+/A+/Zero/Zero W/WH, Consenti Comunicazione Lunga Distanza Tramite RS485/CAN Funzione, Integrato MCP2515 CAN Controller con Chip SN65HVD230 e SP3485
Spedizione gratuita
78
QUALITÀ BUONA
VEDI SU AMAZON
Amazon.it
#7
▼ Mostra di più
▲ Mostra di meno
RS485 CAN HAT for Raspberry Pi 4B/3B+/3B/2B/B+/A+/Zero/Zero W/WH, with standard Raspberry Pi 40PIN GPIO extension header
CAN function, onboard CAN controller MCP2515 via SPI interface, onboard transceiver SN65HVD230
RS485 function, controlled via UART, half-duplex communication, supports automatic TX/RX control without programming, onboard transceiver SP3485
Onboard TVS (Transient Voltage Suppressor), effectively suppress surge voltage and transient spike voltage in the circuit for RS485 transceiving, lightningproof & anti-electrostatic
Reserved control pins, allows to work with other control boards, comes with development resources and manual (examples in wiringPi/python)
19,52 € SU AMAZON
Waveshare
Waveshare 4G/3G/2G/GSM/GPRS/GNSS Hat for Raspberry Pi 4 Jetson Nano Based on SIM7600E-H Supports LTE CAT4 for Downlink Data Transfer
Spedizione gratuita
78
QUALITÀ BUONA
VEDI SU AMAZON
Amazon.it
#8
▼ Mostra di più
▲ Mostra di meno
The SIM7600E-H 4G HAT is a 4G/3G/2G communication and GNSS positioning module, which supports LTE CAT4 up to 150Mbps for downlink data transfer. it is pretty low power consumption.
You can connect this 4G module with computer to surf the Internet, or attach it onto Raspberry Pi to enable functions like 4G high speed connection, wireless communication, making telephone call, sending SMS, global positioning, etc.
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano. Supports SIM application toolkit: SAT Class 3, GSM 11.14 Release 99, USAT.
Baudrate: 300bps ~ 4Mbps (default: 115200bps). Autobauding baudrate: 9600bps ~ 115200bps. Control via AT commands (3GPP TS 27.007, 27.005, and V.25TER command set).
Supports dial-up, telephone call, SMS , mail, TCP, UDP, DTMF, HTTP, FTP, etc. Supports GPS, BeiDou, Glonass, LBS base station positioning.
77,99 € SU AMAZON
KEYESTUDIO
KEYESTUDIO Respeaker 2-Mic Pi Hat v1.0 per Raspberry Pi 4 Module Zero e Zero W, Raspberry Pi B +, Raspberry Pi 2B e 3B/4B
Spedizione gratuita
71
QUALITÀ BUONA
VEDI SU AMAZON
Amazon.it
#9
▼ Mostra di più
▲ Mostra di meno
This is keyestudio respeaker 2-mic pi cappello V1.0 scudo progettato per ai e applicazioni vocali. Si tratta di una bassa potenza stereo Codec basato sul wm8960.
Ci sono due microfoni sullo scudo per il suono Collection, tre apa102 RGB LED, pulsante di un utente e due connettori Grove per estensione di applicazione.
Inoltre, un jack audio da 3.5 mm o XH2.54-2P altoparlante di uscita può essere usato per l' uscita audio.
Con questo prodotto Shield, è possibile costruire una voce più potente e flessibile che si integra Amazon amazona servizi voce, Google Assistant, e molto altro ancora
Supporto tecnico: schema di collegamento, codice di esempio, utilizzando il metodo e le risorse sono forniti nella nostra pagina Wiki. L' assistenza tecnica è disponibile tramite e-mail o messaggio
13,29 € SU AMAZON
IBest
IBest Ethernet/USB HUB Hat B with Box for Raspberry Pi Zero/Zero W/2 W/Zero WH/2 WH,Ethernet USB HUB Hat with Case, 1x RJ45 Ethernet Port,3X USB Ports Compatible with USB2.0/1.1
Spedizione gratuita
68
QUALITÀ BUONA
VEDI SU AMAZON
Amazon.it
#10
▼ Mostra di più
▲ Mostra di meno
ETH-USB-HUB-BOX is Designed for Raspberry Pi Zero, compatible with Zero series boards
3x extended USB ports, compatible with USB 2.0 / 1.1.Incorporates RTL8152B Ethernet chip, supports 1x RJ45 Ethernet port, 10/100M auto-negotiation
Pogo pin design, for direct connecting with Raspberry Pi Zero/Zero W/Zero WH.
Angle rounded design, smooth hand feeling, "simple snap" case lid. Quality ABS material, dull polish surface, anti-fingerprint
Comes with two different lids, changing as you like
23,95 € SU AMAZON
hat raspberry
raspberry zero hat
raspberry fan hat
raspberry tv hat
game hat raspberry
raspberry game hat
raspberry lora hat
raspberry microphone hat
raspberry ups hat
raspberry 4g hat
#1 VINCITORE
